We use cookies to optimize our website for you and to be able to continuously improve it. By continuing to browse the site you are agreeing to our use of cookies.
Disagree
used
Lathe Make: Heyligenstaedt Manual lathe Year of Make: 1958 Overall length: 3825 mm Bed length: 3000 mm Turning length: 1500 mm Weight: 2500 kg optically very good condition technically very good condition little used is currently in operation No guarantee, no return, no warranty Machine is still in commercial use and can be viewed by appointment. Transport from the hall is carried out by the seller, at the expense of the buyer. Loading on trucks is done by the seller, at the expense of the buyer. Corresponding truck (load capacity) provided by buyer.
used
turning diameter: mmturning length: mmswing diameter over bed slide: mmtotal power requirement: kWweight of the machine ca.: trequired space: mThe data for this ad was created with ModulMWS - the software solution of LogoTech oHG.
used
Lathe PPL 200-225 - Turning diameter over bed: 400-450 mm - Turning diameter over slide: 235-285 mm - Offset with bridge: turning diameter 600-650 mm - Face plate diameter: 350 mm - Bed width: 320 mm - Engine power: 5.5 hp - Tool carriage: 150 mm stroke Good condition, fully functional, can be viewed and tried out on site. Shipping also abroad. Viewing: Basically, I would like to point out that the article can be viewed and tested under power before purchase in order to rule out misunderstandings. Please ask questions before purchasing to avoid confusion. If you have any general questions or would like to make an appointment for a viewing, I can be reached at any time on the telephone number below or above. Errors in the description and prior sale excepted. VAT is shown separately on my invoices. Shipping with forwarding agent.
used
faceplate diameter: 1000 mmturning diameter over slide rest: 1200 mmcentre distance: 1500 mmbed indentation: . weight of the machine ca.: 6 tcomes in Sept. to Korschenbroich: . The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.
used
Lard lathe Turning length approx. 2000 mm Turning diameter approx. 1100 mm Center height approx. 450 mm without machine table Basic thread M 55 with M 33 adapter for standard chuck with 5 face plates of 100 – 600 mm diameter was used to turn molds for a foundry. Weight approx. 2800 kg
used
turning diameter over bed: 1000 mmspindle passage: 128 mmturning length: 5000 mmtotal power requirement: 22 kWweight of the machine ca.: 16 tdimensions of the machine ca.: mThe data for this ad was created with ModulMWS - the software solution of LogoTech oHG.
used
turning diameter over bed: 1000 mmspindle diameter: 128 mmturning length: 8000 mmtotal power requirement: 22 kWweight of the machine ca.: 20 tdimensions of the machine ca.: monly one steady is for saleBelt drive shaft bearing damageThe data for this ad was created with ModulMWS - the software solution of LogoTech oHG.
used
serial number: 13691 3-jaw-chuck diameter: 400 mmcentre height: 450 mmcentre distance: 2000 mmtail stock: ja rapid clamping device: 4 seiten digital readout: ja nachgerüstet steady: ja The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.
used
faceplate diameter: 1000 mmturning diameter over slide rest: mmturning length: mmtotal power requirement: kWweight of the machine ca.: tdimensions of the machine ca.: mThe data for this ad was created with ModulMWS - the software solution of LogoTech oHG.