contino 400/2 KLT container washer
The machine is manufactured in a special service provider design and
has a maximum tunnel width of 410 mm and height of 410 mm, which means
that almost all common industrial containers can be cleaned.
Depending on the degree of soiling, the capacity is <200-300
pieces/60/40/h and 200-300 pieces lids 60/40, 40/30 and 30/20.
KITZINGER contino 400/2 KLT hourly output 200-300 boxes and 200-300
lids
Abstract:
- Feed zone with 2000mm straight length driven by narrow stainless
steel strips with firmly welded cams, add. with adjustable side
guides, flow width 160-410mm and 30mm, extended vapour hood with
suction connection in the inlet, top guide for the crates and trays by
means of a stable hold-down device, lids can be fed through
confusion
-Washing zone 1 with 2700mm length external filter tank 10001 with
heating 20kW, washing temperature 55 C, 1 stainless steel centrifugal
pump 4kW 15001 rpm at 1.5bar, stable outer box filter, detergent
should be added to washing zone 1, oil discharge by POLO belt
skimmer
- Washing zone 2 with 2700mm length external filter tank 8001 with
heating 30kW, washing temperature 60; C, 1 stainless steel centrifugal
pump 5.5kW 15001 rpm at 2bar, stable outer box filter, second oil
discharge by POLO belt skimmer
-Washing zone 3 (flushing) with 1800mm length external filter tank
4001 with heating 40kW, rinsing temperature 65°C, 1 stainless steel
centrifugal pump 4kW 10001/min at 2bar, stable outer box filter, final
fresh water rinsing, the fresh water runs into tank 3 and comes out
here as slightly polluted wastewater, if underfilled in tank 1 or 2
the overflow closes and the water is led cascade into tank 1
- 500mm neutral drip zone with suction connection
- 1800mm long blow-off BS2 with 2 blower motors ELEKTROR а 5kW,
adjustable stainless steel air knives blow off the crates, containers
and lids and remove the residual water
- 2700mm long blow-off BS3H with 3 blower motors ELEKTROR а 5kW with
electric auxiliary heating, 15kW power, depending on the
Machine length 16200mm
Machine connections with electric heater
- Fresh water 1 10 C
- Exhaust air 2 x DN 250
- Wastewater DN 50
- Electricity: 400V, 50Hz, 140kW (distributed over 2 control
cabinets)
Machine connections with direct gas heating
- Fresh water 1 10°C
- Exhaust air 2 x DN 250
- Wastewater DN 50
- Electricity: 400V, 50Hz, 40kW
- Gas city gas with 3 connections
- Chimney with 3 connections
Germany
