4 ROLL HYDRAULIC MODEL 1000 x 22mm CNC EVO GRAPHIC 4AXIS PROG
PLATE BENDING ROLL PLANETARY DOUBLE PRE-PINCH PLATE PRE-BENDING
capacity:
-Width of plate: 1000 mm
-Thickness of plate rolling 22 mm
-Thickness of plate pre-bending 16 mm
minimum bending diameter ID 280 mm
depending on the plate thickness vs. yield strength
Rolls -Surface length mm. 1050
-top roll mm. 250
-lower roll mm. 260
-Power electric 15Hp on centralized hydraulic unit , voltage 3ph
Vac 400/50
Configuration installed
• Hardening of the 4 rolls , very high resistance against wear.
• Central rolls both driven powered with axial gearbox and direct
drive hydraulic motor.
• Calibration system for the re-rolling of welded shells rounding
unwanted flat spots.
• Console electric on wheels with centralized commands joysticks
CNC position readout.
• Opening front side hydraulic drop-end unloading closed
shells.
• CNC Digital position of the 4 rolls, CNC programmable 4 axis
graphic CAM autocalc
• Variable speed on proportional valves stepless continuous
controller.
Italy
