Overview of the assembly:
- Release agent spray unit top & bottom
- Joining milling unit 2 x 4 kW
- Glued part with workpiece preheating, 2 rolls, pressure zone C and
QA34 application unit for PU with quick clamping system
- autom. Adjustment pressure zone
- Preparation for Lasertec activation unit
- Hl84 cross-cut unit 0.8 KW
- pneum. Adjustment pre-milling unit
- Pre-milling unit Bf10 1.5 kW
- Mould milling unit Fk11 Manual
- Autom. Adjustment of chamfer to radius milling machines
- Rolling side probe FK
- Pneumatic adjustment FA11 for lateral displacement from the working
area
- Multi-drawing blade MN 21 autom. for a maximum of 5 different
profiles.
- Finishing unit (glue joint drawing blade and swabbing ridge)
- Detergent spray unit top & bottom
- powerControl PC22
Workpiece and edge parameters: - Workpiece width without edge min:
- For workpiece thickness 12-22 mm ¦ 60 mm
- For workpiece thickness 23-40 mm ¦ 105 mm Depends on the workpiece
length
- Workpiece protrusion ¦ 30 mm
- Workpiece thickness ¦ 8 - 60 mm
- Edge material roll ¦ 0.3 - 3 mm
- Edge cross-section max: ¦
- For PVC ¦ 135 mm²
- For veneer ¦ 100 mm²
- Roll diameter max. ¦ 830 mm
- Edge material strips ¦ 0.4 - 20 mm
- Edge cross-section max: ¦
- For strips ¦ 900 mm²
- If no radius is specified, R=2 mm and chamfer 20° are retracted and
delivered
- The machine operator is responsible for the use of suitable
materials (plates, adhesives, edges, cleaning agents, varnishes, etc.)
Germany
